Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
full_syntax [2019/10/10 13:50]
marijn.nijenhuis [5. Optional] |
full_syntax [2020/06/05 13:37]
marijn.nijenhuis [5. Optional] |
| | ''transfer'' | ''true'' | Calculation of state-space equations. Requires specification of at least one input and one output, by means of ''nprops(i).transfer_in'' and ''nprops(i).transfer_out''. Cannot be used with applied forces, applied moments, prescribed displacements, and buckling load multipliers. | | | ''transfer'' | ''true'' | Calculation of state-space equations. Requires specification of at least one input and one output, by means of ''nprops(i).transfer_in'' and ''nprops(i).transfer_out''. Cannot be used with applied forces, applied moments, prescribed displacements, and buckling load multipliers. | |
| | ::: | 1×2 cell | Calculation of state-space equations that include relative damping for all modes of the system. (This value only affects the output in ''out.statespace''; the eigenfrequency output in ''out.freq'' and Spavisual remain undamped.) For example: ''opt.transfer = {true 0.01}'' calculates state-space equations with relative damping 0.01. | | | ::: | 1×2 cell | Calculation of state-space equations that include relative damping for all modes of the system. (This value only affects the output in ''out.statespace''; the eigenfrequency output in ''out.freq'' and Spavisual remain undamped.) For example: ''opt.transfer = {true 0.01}'' calculates state-space equations with relative damping 0.01. | |
| | |''customvis''| ''{'modeshape','maximum 20'}'' | The maximum number of mode shapes, in this case 20, that are shown in the Spavisual window. If omitted, the default value of 10 is used. | |
| ===== Output Arguments ===== | ===== Output Arguments ===== |
| |
