limitations_bugs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
limitations_bugs [2017/10/16 18:43] marijn.nijenhuis |
limitations_bugs [2018/05/16 09:55] mark.naves [Limitations] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Limitations ===== | ===== Limitations ===== | ||
| - | The default SPACAR version distributed via Blackboard supports flexible multibody models with a maximum of 50 flexible deformation modes. For example, if fully flexible beams are considered (meaning there are six flexible deformation modes per beam), a maximum of 8 beam elements can be used. For problems with limited complexity, this should be sufficient. | + | The default SPACAR version distributed via Blackboard supports flexible multibody models with a maximum of 120 degrees of freedom. For example, if fully flexible beams are considered (meaning there are six flexible deformation modes per beam), a maximum of 20 beam elements can be used. For problems with limited complexity, this should be sufficient. |
| Line 8: | Line 8: | ||
| **Read/ | **Read/ | ||
| - | When SPACAR Light (and also the full version) is called, it reads and writes an input and output file to the disk of your computer. When the program is called repeatedly in consecutive calls (for example in an optimization routine), this could result in read/write errors, causing the simulation to fail or even MATLAB to crash (indicating a Fortran/ | + | When SPACAR Light (and also the full version) is called, it reads and writes an input and output file to the disk of your computer. When the program is called repeatedly in consecutive calls (for example in an optimization routine), this could result in read/write errors, causing the simulation to fail or even MATLAB to crash (indicating a Fortran/ |
| To prevent this problem, make sure your MATLAB working directory is not synchronized over the internet (e.g. with an active Dropxbox folder or another cloud service). Best practice is to use a physical (and internal) disk. | To prevent this problem, make sure your MATLAB working directory is not synchronized over the internet (e.g. with an active Dropxbox folder or another cloud service). Best practice is to use a physical (and internal) disk. | ||
limitations_bugs.txt · Last modified: 2018/05/16 09:55 by mark.naves
Page Tools
