limitations_bugs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
limitations_bugs [2017/10/19 12:57] marijn.nijenhuis |
limitations_bugs [2018/05/16 09:55] mark.naves [Limitations] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Limitations ===== | ===== Limitations ===== | ||
| - | The default SPACAR version distributed via Blackboard supports flexible multibody models with a maximum of 60 degrees of freedom. For example, if fully flexible beams are considered (meaning there are six flexible deformation modes per beam), a maximum of 10 beam elements can be used. For problems with limited complexity, this should be sufficient. | + | The default SPACAR version distributed via Blackboard supports flexible multibody models with a maximum of 120 degrees of freedom. For example, if fully flexible beams are considered (meaning there are six flexible deformation modes per beam), a maximum of 20 beam elements can be used. For problems with limited complexity, this should be sufficient. |
limitations_bugs.txt · Last modified: 2018/05/16 09:55 by mark.naves
Page Tools
