Differences

This shows you the differences between two versions of the page.

--- walkthrough [2017/10/18 10:50]
marijn.nijenhuis [Element connectivity]
+++ walkthrough [2017/10/18 10:50]
marijn.nijenhuis [Node properties]
@@ Line 50: / Line 50: @@
 Furthermore, we would like for the parallel flexure guide to start 10mm deflected to the left and let it move 20mm to the right. For this purpose, we pre-describe the position of node 2 in x-direction:
 <code matlab>
-nprops(2).displ_initial_x =-0.01; %start with node 2 displaced 10mm to the left
+nprops(2).displ_initial_x =-0.01; %start with node 2 displaced 10 mm to the left
-nprops(2).displ_x =         0.02; %displace node 2 20mm to the right
+nprops(2).displ_x =         0.02; %displace node 2 20 mm to the right
 </code>
 At last we apply a load of 5N in Z-direction on node 2 and 3
 <code matlab>
-nprops(2).force_initial = [0 0 5]; %initial load of 5N i z-direction
+nprops(2).force_initial = [0 0 5]; %initial load of 5N in z-direction on node 2
-nprops(3).force_initial = [0 0 5]; %initial load of 5N i z-direction
+nprops(3).force_initial = [0 0 5]; %initial load of 5N in z-direction on node 3
 </code>

SPACAR Wiki